Edelbrock 9267 { Sellable : Yes }

The Edelbrock Square-bore Dual Quad Heat Insulator Gaskets #9267 are designed to prevent percolation on Thunder Series and Edelbrock Performer Series Carburetors exposed to extreme under hood temperatures. These gaskets feature a four hole design which will allow dual quad Performer and RPM manifolds to seal properly to the carburetor. Prior to installation, check air cleaner-to-hood clearance to ensure that additional height of heat insulator gaskets will not cause interference. Remove air cleaner and all attachments to the carburetors such as fuel lines, throttle linkage, and vacuum lines. Be sure to note the position or tag each piece to facilitate re-installation. Remove the carburetors and set them, aside, then remove the old base gaskets and any additional plates. Remove the short carb studs and install the longer studs. Install the #9267 heat insulator gaskets directly against the manifold, then replace the carbs and all other connections.

Installation Instructions

Description_ABR	Carb Insulat
Description_DEF	Carburetor Heat Insulator
Description_DES	GASKET
Description_EXT	The Edelbrock Dual Quad Insulator Gasket #9267 is designed to prevent percolation on Edelbrock Performer Series carburetors exposed to extreme under hood temperatures.
Description_EXT	The Edelbrock Dual Quad Insulator Gasket #9267 is designed to prevent percolation on Edelbrock Performer Series carburetors exposed to extreme under hood temperatures.?
Description_FAB	Comes w/Extended Carb Studs
Description_FAB	For Extreme Underhood Temps
Description_FAB	Helps Prevents Fuel Percolation
Description_FAB	Square Bore Applications Only
Description_INV	Dual Quad Insulator Kit (2)
Description_KEY	Edelbrock; Gasket; Heat; Insulator; Carburetor; Carb; Installation; Replacement; Percolation; Performer Series; Thunder Series; AVS; AVS2; Square bore; Dual Quad
Description_LAB	Carburetor Heat Insulator #9267 For Dual-Quad Manifolds
Description_MKT	The Edelbrock Square-bore Dual Quad Heat Insulator Gaskets #9267 are designed to prevent percolation on Thunder Series and Edelbrock Performer Series Carburetors exposed to extreme under hood temperatures. These gaskets feature a four hole design which will allow dual quad Performer and RPM manifolds to seal properly to the carburetor. Prior to installation, check air cleaner-to-hood clearance to ensure that additional height of heat insulator gaskets will not cause interference. Remove air cleaner and all attachments to the carburetors such as fuel lines, throttle linkage, and vacuum lines. Be sure to note the position or tag each piece to facilitate re-installation. Remove the carburetors and set them, aside, then remove the old base gaskets and any additional plates. Remove the short carb studs and install the longer studs. Install the #9267 heat insulator gaskets directly against the manifold, then replace the carbs and all other connections.
Description_SHO	{ Sellable : Yes }
Description_SHP	{ eo : 3in.}
height	9.5
length	10.75
LTL	N
WARNING CA Proposition 65	Yes
WARNING CA Proposition 65 Message	WARNING: This product can expose you to Chromium; which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information; visit www.P65warnings.ca.gov.
weight	8.85
width	8.0